Table of Contents
Advertisement
IGNITION
GENERATOR
CHOKE
THROTTLE
Figure 3. Location of Controls
BEFORE installing on your tractor. Follow the in-
structions which accompany the battery for the proper
procedure of activation. Use the bolts and hold-down
clamp provided and place the battery in position as
shown with battery terminals toward inside of tractor.
Now hook the ground wire, which is the heavy wire
attached to the engine base, to tTie yellow or negative
post of the b a t t e r y . The other heavy wire running
from the starter solenoid should be connected to the
red or positive post. Coat the battery terminals with
petroleum jelly to prevent corrosion.
A T T A C H THE M O W E R A T T A C H M E N T
1. After the rollers (3) and wheels (2) have been se-
curely attached to the mower housing, position the
mower at the left side of the tractor so that it will
slide sideways between the front and rear wheels.
Be certain that the loose belt is on the center main
drive pulley of mower attachment. Turning the
tractor wheels as though making a left turn will
give more room to get the mower under the trac-
tor.
2. The mower "engage & disengage" lever at the right
side of the dash panel must be in the "disengage"
position.
3. Slide the mower sideways under the tractor so that
the side plates of the mower are lined up with the
sides of the tractor chassis and the mower housing
is pushed forward against the front wheels.
Figure 4 . U n d e r s i d e of Chassis
in the arm that extends downf rom the tractor chas-
sis at the right side of the engine (Ref. A in Fig-
ure 4.). Fasten the rod in place with the cotter
pin that is in the rod.
6. Using the (2) loops on the mower side plate lift the
side plate, andfit the (2) holes at the top over the
(2) studs on the side of the tractor chassis. Fasten
with the hairpin provided.
7. Repeat for other side of tractor.
8. Set the tractor lift lever (right side of tractor) at
the lowest position "attach", swing the adjusting
links up on each side of the lift lever until the holes
in the adjusting links line up with the top hole of
the lever. Insert the clevis pin and lock with the
hairpin.
4. Guide the main drive belt onto the (2) mower drive
idler pulleys being sure that the belt is held in
position on the pulleys by the belt guides. The belt
must go between the tie rod and the chassis (see
Figure 4).
Extend the belt up thru the chassis
and on the large engine pulley at the front of the
engine. Keeping the mower well forward will make
the belt loose and easy to install.
5. After the main drive belt is threaded over the pul-
leys push the deck back toward the rear wheels
faf enough to put the blade brake rod into the hole
65TE10&12
f
u
\
Only
I
"
y
Figure 5. G e a r Shift Pattern
4
Advertisement
Table of Contents
