Table of Contents
Advertisement
SERIES MARINE E
CHAPTER 7: SERVICE PROCEDURES
7.1
General
Before performing any maintenance on this equipment, disconnect the fryer from the electrical
power supply.
When electrical wires are disconnected, it is recommended that they be marked in such a way as to
facilitate re-assembly.
7.2
Replacing a Remote Digital Controller
1. Unplug all power cords.
2. Unplug the 15-pin connector from the back of the controller.
3. Remove the mounting screws.
4. Reassemble in reverse order to complete the replacement and return the fryer to service.
7.3
Replacing Component Box Components
1. Disconnect the fryer from the electrical power supply.
2. The front panel bezel is held in place by tabs at the top and bottom. Slide the metal bezel up to
disengage the lower tabs. Then slide the bezel down to disengage the upper tabs.
3. Remove the two screws from the upper corners of the front panel bezel and allow the front panel
bezel to swing down.
4. Remove the front panel bezel assembly by lifting it from the hinge slots in the panel bezel frame.
5. Disconnect the wiring from the component to be replaced, being sure to make a note of where
each wire was connected.
6. Dismount the component to be replaced and install the new component, being sure that any
required spacers, insulation, washers, etc. are in place.
NOTE: If more room to work is required, the control panel frame assembly may be removed by
removing the hex head screws that secure it to the fryer cabinet (see illustration on the following
page). If this option is chosen, all front panel assemblies must be removed per steps 2-4 above.
The cover plate on the lower front of the component box may also be removed if desired.
Removing the component box itself from the fryer is not recommended due to the difficulty
involved in disconnecting and reconnecting the oil-return valve rods, which pass through
openings in the component box.
4
ELECTRIC FRYERS
7-1
Advertisement
Table of Contents
Troubleshooting
