Table of Contents
Advertisement
JOINING KIT INS TALL ATION
Kit Sizes: 60" (1524 mm) / 72" (1828.8 mm) / 78" (1981.2 mm) / 90" (2286 mm) / 102" (2591 mm) / 120" (3048 mm)
K I T C ON T EN T S
• (1) Joining Rainshield Assembly
• (1) Joining Kickplate
• Anti-Sweat Foam End Panels*
• Joining Bracket*
• 1/4-20 x 1" Hex Head Screws*
• 1/4" Split Lock Washers*
*Quantities vary by kit size.
R EQUIR ED T O O L S
WARNING: To avoid a hazard due to instability of
Required tools include (but may not be limited to) the
the appliance, it must be fixed in accordance with
the instructions.
following:
AVERTISSEMENT: Pour éviter tout risque dú a
• Phillips Bit Driver or Screwdriver
l´instabilité del l´appareil, vous devez le fixer
conformément aux instructions.
• 7/16" Socket Wrench
• 1/4" Socket Wrench
• Tape
• Marking Utensil
• Drill
CAUTION!
Electrical shock or burn
hazard. Unplug the unit or turn off the
power supply before proceeding.
WARNING! TIP OVER HAZARD.
To avoid hazards from appliance
instability, be sure to install the anti-tip
brackets (see fig. 1) on each individual
unit per the installation manual instructions.
P R O CEDUR E
1. Remove the reed switch bracket. See figs. 2 and 3.
2. Remove the reed switch cover, and then
disconnect the reed switch. See figs. 4 and 5.
Page 26 of 56
T RUE RE S ID E N TI A L
I N S T A L L A T I O N
R
9 9/32"
236mm
22 31/32"
583mm
PROUD INSTALL
®
WARNING! TIP OVER HAZARD.
A child or adult could tip the appliance,
resulting in property damage or bodily
harm. If the appliance is moved, verify
that the device is properly engaged before the normal
usage of the appliance commences.
FIG. 1.
Anti-tip bracket. Be sure to install a bracket for each unit.
C L
C L
FIG. 2.
Pull the rainshield open.
FIG. 3.
Locate the reed switch in the bottom of the rainshield.
FIG. 4.
Remove the plastic cover.
09/07/2023
TR-30REF-R-SG-A
9 9/32"
236mm
24 31/32"
634mm
FLUSH INSTALL
TEC_TM_236 REV. A_EN
Advertisement
Table of Contents
