Table of Contents
Advertisement
WATER FILTER INS TALL ATION &
PERFORM ANCE DATA
The water filter filters sediment and removes
unpleasant taste and odor. Install the provided water
filter before using the icemaker. The unit will not make
ice until the water filter is installed.
PROCEDURE
1. Remove the kickplate. See fig. 1.
2. Insert the provided water filter (see fig. 2) and
rotate the filter clockwise. (See figs. 3 and 4).
3. Reinstall the kickplate.
WATER FILTER PERFORMANCE DATA
• This system has been tested according to NSF/ANSI
Standard 42, 53, 372, 401, P473 and CSA B483.1
for reduction of the substances listed below. The
concentration of the indicated substances in water
entering the system was reduced to a concentration
less than or equal to the permissible limit for water
leaving the system, as specified in NSF/ANSI
Standards 42, 53, 372, 401, P473 and CSA B483.1.
• Systems certified for cyst reduction may be
used on disinfected waters that may contain
filterable cysts. The system conforms to NSF/
ANSI 42, 53, 372, 401,P473 and CSA B483.1 for
the specific performance claims as verified and
substantiated by test data. Conforms to NSF/ANSI
53 for VOC reduction. See next page for individual
contaminants and reduction performance.
NO T E: T E S T ING WA S P ER F O R MED UND ER
S TA NDA R D L A B O R AT O RY C ONDI T ION S,
A C T UA L P ER F O R M A NCE M AY VA RY.
TEC_TM_236 REV. A_EN
I N S T A L L A T I O N
FIG. 1.
Pull the kickplate from the appliance.
FIG. 2.
Locate the provided water filter shipped in the ice bucket.
FIG. 3.
Insert the water filter and rotate it clockwise.
FIG. 4.
Installed water filter.
09/07/2023
T R- 3 0 RBF IN STA L L M A NUA L
Page 23 of 56
Advertisement
Table of Contents
