Table of Contents
Advertisement
Servicing Information
PAIRING THE REMOTE
SIGNAL CODE
The below operations should be carried out before coding
when changing to a new remote or the unit cannot be
controlled by the remote:
The reset button is located on the control panel located on the
right-hand side of the appliance.
Press the reset button for 3 seconds (a pen point may be needed)
until 3 short beeps sound from the unit, release the button.
Within 10 seconds, press the
finished when 1 long beep sounds from the unit.
Reset Button for Remote Control
Resetting of the remote control is necessary if the
appliance operates wrongly due to external interference
signal and the remote control is not in use.
Open the back cover of the Remote.
Press the Reset button for 3 seconds and reset the coding.
SERVICING
button on remote. The coding is
IMPORTANT: Prior to performing any service work, ensure the
power is shut off to appliance either by disconnecting 3 prong
plug or shutting off breaker if appliance has been hardwired.
ACCESSING THE FUEL BED
Carefully use the glass suction lifter provided to remove the glass
by lifting the pins clear of the slots on the front of the appliance.
1
1
2
Gently place the glass to one side.
2
Glass suction
lifter
43
Advertisement
Table of Contents
