Table of Contents
Advertisement
7. JOIN AND SEAL MODULE SECTIONS
CAUTION: Risk of product damage. Clean
inside floor and position protective material on
inside floor of module.
Wearing gloves and using a soft, damp cloth, carefully
wipe the joining surfaces of each module section to
remove any dust or dirt.
Apply 2" wide masking tape along the entire length of the
joining surfaces inside each module section.
Carefully position the module top section on the bottom
section.
Position the alignment strips, and slide the alignment
clips into place.
Temporarily support the top module section by inserting
a set of three washers at each corner of the module.
Another set of three washers should be positioned along
the middle of the back wall. Fit the washers between the
upper and lower mounting block sections so they do not
block the bolts holes, and so they do not protrude into the
wall joint.
Reinstall the bolts into the upper blocks, and gently tap
them into the corresponding lower blocks.
Working from the inside of the module, apply a generous
bead of clear silicone sealant inside the entire length of
the joint. Check the bead, and fill in any voids.
TE:
NO
Clear silicone sealant is a superior product to
ensure against leaks. Use of acrylic or other caulks is not
recommended. Sealant may set up quickly. Proceed to
the next steps immediately.
BA
116014-2-
(-)
Alignment
Strip
Mounting Block
Sealant Bead
10
Alignment
Clip
Module Joining
Edge
Washers
Top Section
Masking Tape
Masking Tape
Bottom Section
Kohler Co., Kohler, WI
Advertisement
Table of Contents
