Table of Contents
Advertisement
If you are a system integrator, VAR or OEM, a POST
diagnostics card is recommended for port 80h codes.
Refer to Appendix D.
Memory Error
If you encounter memory error, follow the procedures below.
1.
Check to determine if DIMM modules are improperly installed.
2.
Make sure that different types of DIMMs have not been installed
in different banks (e.g., a mixture of 2MB x 36 and 1 MB x 36
DIMMs in Banks 0).
3.
Determine if different speeds of DIMMs have been installed in
the same or different banks, and the BIOS setup is configured
for the fastest speed of RAM used. It is recommended to use
the same RAM speed for DIMMs in different banks.
4.
Check for bad DIMM modules or chips.
Losing the System's Setup Configuration
1.
Ensure that you are using a high quality power supply. A poor
quality power supply may cause the system to lose CMOS
setup. Refer to Chapter 1 of this manual for details.
2.
If the above step does not fix the Setup Configuration problem,
contact your vendor for repair.
Chapter 3:
NOTE
3-3
Troubleshooting
Advertisement
Table of Contents
Troubleshooting
