Supermicro SUPER P6DLE User Manual page 38

SUPER P6DLS/P6DLE/P6SLS/P6SLA User's Manual
4. Slid the clip (A) on each support toward the processor, exposing
the hole that will fit over the peg on the motherboard. Push the
latches (B) on the processor toward the center of the processor
until they click into place.
5. Hold the processor so that the fan shroud is facing toward the
pegs on the motherboard. Slide the processor (C) into the reten-
tion mechanism and slide the supports onto the pegs. Ensure that
the pegs on the motherboard slide into the holes in the heatsink
support and that the alignment notch in the SEC cartridge fits over
the plug in Slot 1. Push the processor down firmly, with even pres-
sure on both sides of the top, until it is seated.
Figure 2-3. Retention Mechanism
B
C
A
Do not screw too tight!
2-4