Parallel Port Connector - Supermicro SUPER P6DLE User Manual

select jumper on the drive to DS2 (or Slave). Consult the docu-
mentation that came with your disk drive for details on actual
jumper locations and settings.
• A single SCSI ribbon cable typically has three connectors to pro-
vide for two hard disk drives and the SCSI adapter. (Note: most
SCSI hard drives are single-ended SCSI devices.)
is determined by jumpers or a switch on the SCSI device.
last internal (and external) SCSI device cabled to the SCSI
adapter must be terminated.
• Some drives require a special controller card.
drive manual for details.

Parallel Port Connector

The parallel port is located on J19.
tions.
Table 2-21. Parallel Port Pin Definitions
Pin
Number
1
3
5
7
9
11
13
15
17
19
21
23
25
Chapter 2:
See Table 2-21 for pin defini-
Pin
Function Number
Strobe- 2 Auto Feed-
Data Bit 0 4 Error-
Data Bit 1 6 Init-
Data Bit 2 8 SLCT IN-
Data Bit 3 10 GND
Data Bit 4 12 GND
Data Bit 5 14 GND
Data Bit 6 16 GND
Data Bit 7 18 GND
ACK- 20 GND
BUSY 22 GND
PE 24 GND
SLCT 26 NC
2-21
Installation
The SCSI ID
The
Read your disk
Function