Setup; Adjusting The Machine Settings; Mounting The Battery Charger On A Wall; Charging The Batteries - Toro GrandStand 18840TE Operator's Manual

Setup

Adjusting the Machine
Settings
Use the InfoCenter to adjust the machine settings;
refer to InfoCenter Display (page
Mounting the Battery
Charger on a Wall
Optional
You can mount the charger on a wall using the
wall-mount key holes cut into the back of the unit. Use
screws that have a 6 mm (1/4 inch) diameter shaft
and a head diameter of 11 mm (0.45 inch).
Important:
Survey your work area and determine
a location that best meets the criteria for safe and
effective operation of the charger.

Charging the Batteries

Check the battery-system charge; charge them as
needed. Refer to Monitoring the Battery-System
Charge Level (page 23).
11).
10

Product Overview

1. Front caster wheel
2. Battery cover
3. Control panel
4. Motion-control levers
Figure 3
5. Battery-disconnect switch
6. Battery charger port
7. Platform (down position)
8. Mower deck
g407499