Table of Contents
Advertisement
13. Loosen 2 screws (Binding) [1] and remove 2 screws (Binding) [2] and remove the connector cover [3] of the upstream
Booklet Trimmer.
Press the "SW4" button [4] to display "S03" in the Service Maintenance Panel [5].
CAUTION:
When removing the Two-Knife Booklet Trimmer and returning only to the configuration of the Booklet Trimmer, be sure to
press the "SW4" button "4" and return the Service Maintenance Panel display from "S03" [5] to "S01".
14. Install the Connector cover (4 screws).
15. Turn on the power of the host machine.
NOTE:
Then turn OFF power to enable the settings when power is turned ON.
[5]
TrimMode
VXX.XX
S03
Test
Trim
Start
SYS
SW1SW2SW3SW4
[4]
[ 3 ]
[ 1 ][ 2 ]
914
6. Paper Output Options
Advertisement
Table of Contents
