Table of Contents
Advertisement
13. Secure the Buffer Cable in place using the Wire Saddle. (When the Buffer Path Unit is installed)
NOTE:
If you are concerned with alignment of the Left Deck Cover, perform the following steps to adjust the position of the Left Deck
Cover as necessary.
1. Loosen the 5 screws, and adjust the position of the Left Deck Cover using the scale as reference.
2. Tighten the 5 screws you loosened.
< Adjustment of the Cassettes 3 and 4 >
1. Measure the left margin of the image.
Check that the measured value is within the specified range shown below. When the result is out of the specified range,
perform adjustment by following the following procedure.
• Standard Values : L4 = 2.5 +/- 1.0 mm
2. Pull out the Cassette.
1x
4x
L4
97
2. Host Machine
Advertisement
Table of Contents
