Table of Contents
Advertisement
■ Points to Note on Installation
• Illustrations used in this procedure are those of the Booklet Finisher unless otherwise specified.
• Refer to "Order of Installation of Options" when installing this equipment.
• Since this machine is heavy (Staple Finisher: approx. 36kg, Booklet Finisher: approx. 60kg), 2 or more persons are required
to install it. Be sure to perform the work in accordance with the standard to handle a heavy load in each country.
• When moving this equipment after having unpacked it, be careful by placing a plate, etc. on areas with steps to prevent the
casters from hitting those steps. If the casters hit a step, the casters or the base plate may be deformed.
CAUTION:
When tightening the screws, do not tighten them too tightly. Otherwise, there is a risk of damage and deformation of screw
holes.
■ Order of Installation of Options
1. Buffer Pass Unit *1
2. Document Insertion Unit or Document Insertion/ Folding Unit
3. Puncher Unit
4. Jogger Kit
5. Staple Finisher or Booklet Finisher (This equipment)
6. Long Sheet Tray
*1:When installing the Finisher, it is necessary for the Buffer Pass Unit to be installed.
■ Product Name
Safety regulations require the product's name to be registered. In some regions where this product is sold, the following names
may be registered instead.
[5]
[4]
[3]
[6]
[4]
[1]
[2]
[5]
[6]
765
6. Paper Output Options
[2]
[3]
Advertisement
Table of Contents
