Sharp FO-2081 Operation Manual page 145

TROUBLESHOOTING AND MAINTENANCE
Display messages (Error Code)
Error Code
CE-00 CE-01
CE-02 CE-04
CE-03
CE-05
CE-09
CE-12
MEMORY FULL
144
Solution
Turn off the power and turn it back on.
Consult with your network administrator to
make sure that no problems exist on the
network or in the server. If the error is not
cleared after turning the power off and on,
turn off the power and contact your dealer.
Server access denied. The scanned
image was not sent because a connection
to the server could not be established.
Make sure that the SMTP server settings
or FTP server settings in the Web page
are correct. The procedure for configuring
the SMTP server is explained in "Various
server settings", and the procedure for
editing Scan to FTP destination
information is explained in "Editing and
deleting programmed transmission
destinations".
The scanned image was not sent because
the server was busy or there was too
much traffic. Wait briefly and then try
again.
The scanned image was not sent because
the directory of the destination FTP server
was not correct. Make sure that the correct
FTP server information is configured in the
Web page.
The size of the scanned image file
exceeds the upper limit set in "Maximum
Size of File" in the Web page. Reduce the
number of original pages scanned into the
file, or change the upper limit set in
"Maximum Size of File".
The maximum number of destinations that
can be searched has been exceeded.
Increase the number of search characters
to narrow the range of the LDAP search.
The memory became full during scanning.
Scan less pages, lower the resolution, or
change the color mode so that the file size
is smaller, and try scanning again. For the
scan mode settings, see "Storing scanning
settings - Scan to USB". (See Help in the
Web page for explanations of each of the
settings.)
Page
-
110, 115
-
110
113
121
94