Table of Contents
Advertisement
WARNING
FIRE AND EXPLOSION HAZARD
Always maintain a minimum of 1 in. clearance
between rotating agitator parts and container
to prevent sparks from contact.
Typical Installation
air line lubricator
air line filter
air regulator
and gauge
NOTE: Reference numbers and letters in parentheses
refer to the callouts in the figures and in the Parts
Drawings.
Grounding
Proper grounding is an essential part of maintaining a
safe system.
To reduce the risk of static sparking, the mounting cover
and all electrically conductive objects or devices in the
dispensing area must be properly grounded. Check your
local electrical code for detailed grounding instructions for
your area and type of equipment.
To ground the agitator, connect one end of the ground
wire (A) to the ground connector (B) on the agitator. See
Fig.1. Connect the other end of the ground wire to a true
earth ground.
For an additional ground wire and clamp, order Part No.
237569.
A
Fig. 1
4 308609
Installation
agitator motor
mix tank
(reference only)
B
Assembling and Positioning the Agitator
With an Elevator
Mount the drum cover as described in manual 306287.
The elevator must be in the down position when you do
any work on the elevator, agitator, or drum cover
assembly. Do not go under the elevator when it is
raised. Proceed to step 1 in With or Without an
Elevator.
Without an Elevator
If your system does not have an elevator, you should
install the Handles Kit to facilitate handling the drum
cover and agitator. Two people are needed to safely lift
and move the drum cover and agitator. To order the
Handles Kit, order Part No. 237524.
Place two standard 55 U.S. gallon (45 Imperial gallon)
barrels 14 in. (approximately 36 cm) apart, and center the
drum cover on the barrels with the Graco logo centered
and facing you, as shown in Fig. 2. Proceed to step 1 in
With or Without an Elevator.
14 in. (36 cm)
Fig. 2
Assembling and Positioning
Agitator Without an Elevator
05734
Advertisement
Table of Contents
