Table of Contents
Advertisement
9.11 Pyrolysis: automatic oven cleaning
Pyrolysis may be carried out at any time of the day or night (if you wish to benefit
from the lower cost of electricity overnight).
During the first automatic cleaning cycle, unpleasant odours may occur due to
the normal evaporation of oil y manufacturing substances. This is an absolutel y
normal phenomenon which disappears after the first cleaning cycle.
Before starting the automatic cleaning cycle, make sure that the oven does not
contain any foods or large spills from previous cooking operations.
During the pyrol y sis cycle, a door locking device makes it impossible to open the
door.
9.11.1 Before starting the automatic cleaning cycle
Pyrolysis may be carried out at any time of the day or night (if you wish to benefit
from the lower cost of electricity overnight).
•
Completely remove all accessories from inside the oven, including the upper
guard.
•
Remove the guide frames, see "9.6.1 Removing guide frames (where
present)".
In order not to damage the internal glass panel, it should be cleaned in
accordance with the usual procedure (see 9.7 Cleaning the door glazing) before
starting the automatic cleaning cycle.
For very stubborn encrustations, lock the door using the pins provided and
remove the glass panel. Spray an oven cleaning product onto the glass (read
the warnings on the product); leave for 60 minutes, then rinse and dry the glass
using kitchen roll or a microfiber cloth. After carrying out these operations,
position the glass panel on the door again and remove the pins locking it..
•
At the end of the cleaning cycle, when the oven has cooled down, reinsert
the frames by repeating the previously used procedure in reverse order.
•
Make sure that the oven door is firmly closed.
90
Instructions for the user
Advertisement
Table of Contents
