Table of Contents
Advertisement
PRE INSTALLATION
2.2
OPERATING ENVIRONMENT
Cases have been factory tested to ISO 23953, +25
at 60% RH, and cross draft of maximum 0.2m/s. For
best performance, we recommend maintaining store
temperature below +24
To avoid condensation build-up, cases should be
positioned to allow air to freely circulate around the
underside and rear of the case
must be level.
Open refrigerated cases are sensitive to excessive air
disturbances. Air currents passing around cases will
seriously impair their operation. Do NOT allow air
conditioning, electric fans, open doors, or windows,
etc., to create air currents around the cases.
Place the case away from any heat sources as the heat
radiation and heat currents will impair the performance.
The exterior of these cases provide space for air
circulation. However, if the store conditions are outside
the recommended limits, a fan ventilation kit can be
requested.
2.3
HANDLING AND TRANSPORTING CASES
Case dimensions and case weight can be found on the
rating plate. Also refer to the latest Product Engineering
Data (PED) available from Hussmann Customer Service.
Always ensure that the moving device is of a suitable
type, and has sufficient lifting capacity for the case
weight and dimension. Always lift cases from the
underside.
NOTE: These cabinets are heavy and
can have high centres-of-gravity (thus
'tippy'). Use appropriate PPE and tools
and manpower levels.
PAGE 9
C at 50% RH.
o
(refer page 7).
Cases
C
It is the responsibility of the transport company to
o
insure adequate loading strategies are implemented to
insure the safe transportation of the Hussmann cases.
Cases should be strapped using the indicated strapping
points highlighted on the case packaging with the "strap
here" stickers. Cases should be strapped in position
ready for transport with the appropriate rated strapping
and strap corner protector. Cases need to be secured
correctly during road transport to insure damage free
delivery. In Australia, cases should not be transported
without the strap corner protectors to insure that the tie
down web straps used from cutting into packaging and
or causing damage to case panels in transport.
The strap corner protector is a case transport
requirement in Australia, and disregarding using the
protector may cause transport damage. Warehouse
Managers may refuse loading without the necessary
implementation of correct strapping protection.
Transportation requirements are to ensure case
integrity and prevent unnecessary damage and avoid
delays in the case installation schedule.
Move the merchandiser as close as possible to its
permanent location and then remove all packaging.
Check for damage before discarding packaging.
Remove all separately packed accessories such as kits
and shelves.
NOTE:
https://www.youtube.com/
watch?v=C5wPzfFSc8Q
Strap Piece
FIGURE 2B
PSM15E3R SEMI-VERTICAL - HUSSMANN
For demonstration watch:
Advertisement
Table of Contents
