Fitting Shelves - Hussmann PSM15E3R Installation Manual

INSTALLATION
3.5

FITTING SHELVES

Although the shelf sizes may vary, the installation and
fitting will remain the same.
Using the hook bracket shown down below. Lift the
shelf up to the back vertical bracket. The height is
independently adjustable by which holes you put the
bracket on. Make sure you level the shelf by inserted
the bracket in its corresponding hole on the other side.
Back Vertical
Bracket
Shelf Bracket
PAGE 18
TILTING SHELVES
The shelves can be titled downward in between 0
30 . This is done by the placement of hinges on the
0
shelf brackets.
FIGURE 3M
FIGURE 3N
FIGURE 3O
NOTE:
The shelves are not able to be
tilted upward.
CAUTION:
Do not exceed the weight
limit of each shelf. Each shelf has
a total maximum weight limit of
180kg/m2.
NOTE:
If the case shelf arrangement
has been deviated significantly from
original specified setup, then product
temperature may be affected.
The quantity and location of shelving
may affect cabinet performance. Refer
to PED sheet and/or your refrigeration
service provider.
PSM15E3R SEMI-VERTICAL - HUSSMANN
0
0
30
0
and
0
FIGURE 3P