Table of Contents
Advertisement
CAUTION
Before proceeding with the reassembly,
make sure that support plate (8) of the
b r a k e c a l l i p e r ( 9 ) i s p o s i t i o n e d
c o r r e c t l y ; t h e p l a t e s l o t m u s t b e
inserted in the appropriate stop pin in
the inner part of the swinging arm right
section.
Insert the disc in the brake calliper
carefully.
u
Position the wheel between the swinging
arm sections on the support (1).
WARNING
Do not insert your fingers between the
chain and the rear sprocket.
u
Make the wheel advance and position
the drive chain (5) on the rear sprocket
(6).
u
Uniformly apply a moderate quantity of
grease on the wheel shaft (4), see page
93 (LUBRICANT CHART).
66
use and maintenance Pegaso 650 I.E. STRADA - TRAIL
1
5
Danger of injury. Do not insert your
fingers to align the holes.
u
Move the wheel backwards, until its
central hole and the holes on the
swinging arm are aligned.
u
Rotate the support plate (8), complete
with brake calliper (9) and with fulcrum
on the stop pin, until it is aligned with the
holes.
u
Introduce the wheel shaft (4) completely
from the left side.
NOTE
Make sure that the wheel shaft
(4) is completely inserted.
u
Position the washer (3) and tighten the
wheel nut (2) manually.
u
Lock the rotation of the wheel shaft (4)
with the appropriate wrench and tighten
the nut (2).
Wheel nut tightening torque (2): 100 Nm
(10 kgm).
WWW.PlandeGraissage.ORG
6
2
3
WARNING
7
4
u
Make sure that the following components
are not dirty:
– tyre;
– wheel;
– brake disc.
CAUTION
After reassembly, pull the rear brake
lever repeatedly and check the correct
braking system operation.
Have the tightening torques, centring
and balancing of the wheel checked by
an aprilia Authorised Dealer, in order
to avoid accidents that may be harmful
for you and/or other people.
8
1
Advertisement
Table of Contents
