Table of Contents
Advertisement
PRELIMINARY CHECKING OPERATIONS
Component
Check the operation, the idle stroke of the control levers, the fluid level and make
Front and rear disc
sure there are no leaks.
brakes
Check the wear of the pads.
If necessary, top up the fluid tank.
Make sure that it works smoothly and that it is possible to open and close it
Throttle
completely, in all steering positions. If necessary, adjust and/or lubricate it.
Engine oil
Check and/or top up if necessary.
Check the tyre surface, the inflation pressure, wear and tear and any damage.
Wheel/tyres
Remove any foreign matter that may be stuck in the tread grooves.
Make sure that they work smoothly.
Brake levers
Lubricate the articulations and adjust the stroke if necessary.
The idle stroke at the end of the clutch lever must be approximately 10 mm; the clutch
Clutch
must work without jerking and/or slipping.
Steering
Make sure that the steering rotates smoothly, without any clearance or looseness.
Side stand and
centre stand
Make sure that it operates correctly. Make sure that when the stand is let up or down
(supplied as
there is no friction and that the spring tension brings it back to its normal position.
standard equipment
If necessary, lubricate joints and articulations.
in the countries
Make sure that the safety switch operates correctly.
where required)
Make sure that the fastening elements are not loose. If necessary, adjust or tighten
Fastening elements
them.
Drive chain
Check the slack.
Check the fuel level and top up, if necessary.
Fuel tank
Check the circuit for leaks.
Make sure that the fuel cap is correctly closed.
The coolant level in the expansion tank must be included between "MAX COLD
Coolant
LEVEL" and "MIN" marks.
Engine start stop
Make sure that it operates correctly.
switch (
-
-
)
Lights, warning lights
LED, horn, rear
Check horn and indicators for proper operation. Change bulbs or fix a failure, if
brake light switch
necessary.
end electric devices
Check
WWW.PlandeGraissage.ORG
Page
33 (BRAKE FLUID - recommendations), 34
(DISC BRAKES), 35 (FRONT BRAKE), 37
(REAR BRAKE), 72 (CHECKING THE
BRAKE PAD WEAR)
74 (ADJUSTING THE ACCELERATOR
CONTROL)
41 (ENGINE OIL), 61 (CHECKING THE
ENGINE OIL LEVEL AND TOPPING UP)
40 (TYRES)
43 (ADJUSTING THE REAR BRAKE
CONTROL LEVER CLEARANCE)
42 (CLUTCH)
–
81 (CHECKING THE SWITCHES)
–
68 (DRIVE CHAIN)
31 (FUEL)
38 (COOLANT), 39 (CHECKING AND
TOPPING UP)
25 [ENGINE START / STOP SWITCH (
)]
77 (BATTERY) – 86 (CHANGING THE
NUMBER PLATE BULB)
use and maintenance Pegaso 650 I.E. STRADA - TRAIL
-
-
47
Advertisement
Table of Contents
