Table of Contents
Advertisement
CAUTION
Do not operate the rear brake lever after
removing the wheel, since the pistons
may go out of their seats and cause
brake fluid leakage. In this case consult
an aprilia Authorised Dealer, who will
carry out the proper maintenance
operation.
Proceed with care. If the final drive
assembly (9) is mounted to the flexible
coupling holder (10), do not turn the rear
wheel over or place it horizontally lying on
the rear chain sprocket (A) side, or the final
drive assembly will come off and the
sprocket (6) might damage.
9
11
NOTE
The removal of the final drive unit
is not necessary if the wheel is in the
normal running position (vertical) or in
horizontal position with the rear sprocket
facing upwards and in both cases secured
against overturning.
NOTE
Do not disturb the five nuts (11).
T h e w h o l e f i n a l d r i v e u n i t m u s t b e
withdrawn from the flexible coupling
holder.
u
Using both hands work (B) on sprocket
(6) outer diameter and slide out the final
transmission assembly (9), hold it
parallel to the wheel shaft.
u
Remove the five flexible couplings from
the flexible coupling holder (10).
WWW.PlandeGraissage.ORG
10
11
NOTE
Check the conditions of the five
flexible couplings; if they are damaged or
excessively worn, change them, see page.
58 (REGULAR SERVICE INTERVALS
CHART).
REASSEMBLY
NOTE
Insert the final transmission unit,
parallel to the wheel axis, introducing the
drive pins in the relevant seats, between a
flexible coupling and the other.
u
Position the five flexible couplings in the
relevant seats in the flexible coupling
holder (10).
u
Using both hands work (C) on sprocket
(6) outer diameter and slide in the final
transmission assembly (9) inside holder
(10).
use and maintenance Pegaso 650 I.E. STRADA - TRAIL
65
Advertisement
Table of Contents
