Control Panel; Installing Or Removing Drives; Accessing The Drive Bays - Supero 1122GG-TF User Manual

A+ Server 1122GG-TF User's Manual
Power Supply
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in Chapter 5: Advanced Serverboard Installation.
6-3

Installing or Removing Drives

Accessing the Drive Bays

Hard Drives: The six hard drive bays can be accessed from the front of the chassis
without opening the chassis top cover.
Peripheral Drives: The chassis includes space for a variety of peripheral drive op-
tions, including a DVD drive, a floppy drive or a 2.5" hard disk drive. These require
opening the chassis cover for installation. For a complete listing of peripheral drive
options, consult the Supermicro web site at:
http://www.supermicro.com/products/chassis/1U/818/SC818G-1400.cfm
Figure 6-1. Chassis: Front and Rear Views
Hot-Swap Drive Bays (6)
PCI Slot Dedicated IPMI LAN Port
USB Ports LAN Ports VGA Port
6-2
Control Panel
COM Port
UID