Control Panel; System Fans - Supero AS-1021TM-INF Plus User Manual

AS1021TM-T+/1021TM-INF+ User's Manual
Control Panel: Primary Serverboard
LAN Ports PCI-Express x16 Slot
USB Ports COM Port VGA Port
*The 20 Gb Infi niBand ports are included on the 1021TM-INF+ only.
6-2

Control Panel

Each control panel on the front of the chassis must be connected to the JF1 con-
nector on its assiciated serverboard to provide you with system control buttons and
status indicators. (When viewed from the front of the chassis, the serverboard on
the left is referred to as the primary serverboard and the serverboard on the right
as the secondary.)
These wires have been bundled together in a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the control panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all
excess cabling out of the airfl ow path. The LEDs inform you of system status for
the serverboard it is connected to. See Chapter 3 for details on the LEDs and the
control panel buttons. Details on JF1 can be found in Chapter 5.
6-3

System Fans

Each serverboard has its own set of three 4-cm high-performance fans (for a total of
six in the chassis) to provide the cooling for the SuperServer 1021TM-T+/1021TM-
INF+. Fan speed may be controlled by a setting in BIOS (see Chapter 7).
Figure 6-1. Chassis Front View
SATA Drives
Figure 6-2. Chassis Rear View
Power Supply
Infi niBand Port* USB Ports COM Port VGA Port Infi niBand Port*
6-2
Control Panel: Secondary Serverboard
LAN Ports PCI-Express x16 Slot