System Fan Failure; Drive Bay Installation/Removal; Accessing The Drive Bays - Supero AS-1021TM-INF Plus User Manual

System Fan Failure

If a fan fails, the remaining fans will ramp up to full speed and the overheat/fan fail
LED on the control panel will blink on and off. Replace any failed fan at your earliest
convenience with the same type and model (the system can continue to run with a
failed fan). Remove the top chassis cover while the system is still running to deter-
mine which of the fans has failed. Then power down the system before replacing a
fan. Removing the power cord is also recommended as a safety precaution.
Note: the fan fail LED will only give indication of a fan failure when the Fan Speed
setting in the BIOS is set to "3-pin Server".
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays

SATA Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace SATA drives.
Proceed to the next step for instructions. Note: The operating system you use must
have RAID support to enable the hot-swap capability of the SATA drives.
Use caution when working around the SATA backplane. Do not
touch the backplane with any metal objects and make sure no
cables touch the backplane. Also, regardless of how many SATA
!
drives are installed, all four drive carriers must remain in the
chassis to maintain proper airfl ow.
SATA Drive Installation
The SATA drives are mounted in drive carriers to simplify their installation and
removal from the chassis. These carriers also help promote proper airfl ow for the
system. For this reason, even empty carriers without drives installed must remain
in the chassis.
Mounting a SATA Drive in a Carrier
1. Install the drive into the carrier with the printed circuit board side facing down
so that the mounting holes align with those in the carrier.
2. Secure the drive to the carrier with four screws, as shown in Figure 6-3.
Chapter 6: Advanced Chassis Setup
6-3