Supero AS-1021TM-INF Plus User Manual page 46

AS1021TM-T+/1021TM-INF+ User's Manual
Overheat/Fan Fail LED (OH)
Connect an LED to the OH connection
on pins 7 and 8 of JF1 to provide ad-
vanced warning of chassis overheat-
ing or fan failure. Refer to the table on
the right for pin defi nitions and status
indicators.
NIC2 (LAN2) LED
The LED connections for LAN2 are
on pins 9 and 10 of JF1. Attach LAN
LED cables to display network activ-
ity. See the table on the right for pin
defi nitions.
NIC1 (LAN1) LED
The LED connections for LAN1 are
on pins 11 and 12 of JF1. Attach LAN
LED cables to display network activ-
ity. See the table on the right for pin
defi nitions.
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. Attach the
hard drive LED cable here to display
disk activity (for any hard drives on
the system, including Serial ATA and
IDE). See the table on the right for
pin defi nitions
Power On LED
The Power On LED connector is lo-
cated on pins 15 and 16 of JF1. This
connection is used to provide LED
indication of power being supplied to
the system. See the table on the right
for pin defi nitions.
OH/Fan Fail LED
Pin Defi nitions (JF1)
Pin# Defi nition
7 Vcc
8 Control
NIC2 LED
Pin Defi nitions (JF1)
Pin#
9
10
NIC1 LED
Pin Defi nitions (JF1)
Pin#
11
12
HDD LED
Pin Defi nitions (JF1)
Pin#
13
14
Power LED
Pin Defi nitions (JF1)
Pin#
15
16
5-12
OH/Fan Fail
LED Status
State Indication
Solid Overheat
Blinking Fan fail
Defi nition
Vcc
Ground
Defi nition
Vcc
Ground
Defi nition
Vcc
HD Active
Defi nition
5V Stby
Control