Supero AS-1021TM-INF Plus User Manual page 63

AS1021TM-T+/1021TM-INF+ User's Manual
Restore on AC Power Loss
This setting allows you to choose how the system will react when power returns
after an unexpected loss of power. The options are Power Off, Power On and Last
State.
MPS Revision
This setting allows the user to select the MPS revision level. The options are 1.1
and 1.4.
SATA Confi guration
Serial ATA Devices
This setting is used to determine if SATA drives will be used and how many. Options
are Disabled, Device 0 and Device 0/1.
nVidia RAID Function
This setting is used to Enable or Disable the nVidia ROM. If Enabled, the setting
below will appear.
SATA0/1 Primary/Secondary Channel
This setting is used to Enable or Disable the SATA0 Primary, SATA0 Secondary,
SATA1 Primary and SATA1 Secondary, channels (four settings total). If enabled,
the following settings will appear:
SerialATA 0/1 Primary/Secondary Channel
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive.
The options are Disabled and Auto.
Block (Multi-Sector Transfer)
Block mode boosts IDE drive performance by increasing the amount of data
transferred. Only 512 bytes of data can be transferred per interrupt if block
mode is not used. Block mode allows transfers of up to 64 KB per interrupt.
Select "Disabled" to allow the data to be transferred from and to the device
one sector at a time. Select "Auto" to allows the data transfer from and to the
device occur multiple sectors at a time if the device supports it. The options are
Auto and Disabled.
7-4