Adding Pci Cards - Supero AS-1021TM-INF Plus User Manual

AS1021TM-T+/1021TM-INF+ User's Manual
Note: 256 MB, 512 MB, 1 GB, 2 GB and 4 GB memory modules are supported.
It is highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the H8DMT+/H8DMT-INF+.
Support
The H8DMT+/H8DMT-INF+ supports single or dual-channel, DDR2-667/533/400
registered ECC SDRAM. Only interleaved memory is supported, so you must
populate two DIMM slots at a time (see procedure above).
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
64 GB of DDR2-667/533/400 registered ECC SDRAM in each serverboard.
5-7

Adding PCI Cards

PCI-Express 2.0 Slot
The 1021TM-T+/1021TM-INF+ includes two preinstalled riser cards designed spe-
cifi cally for use in the SC808T-980 1U rackmount chassis. These riser cards support
two low-profi le PCI-Express cards to fi t inside the chassis.
PCI Card Installation
The riser card has already been preinstalled into the serverboard. Perform the fol-
lowing steps to add a PCI add-on card:
1. Remove the PCI slot shield on the chassis by releasing the locking tab.
2. Insert the add-on card into the riser card.
3. Secure the add-on card with the locking tab.
5-8