Supero AS-1021TM-INF Plus User Manual page 59

AS1021TM-T+/1021TM-INF+ User's Manual
Installing a New Power Supply
1. Replace the failed unit with the exact same power supply model from
Supermicro.
2. Carefully insert the new unit into position in the chassis and secure it with the
two screws at the rear of the unit.
3. Before reconnecting the power cord, make sure the power switch on the
power supply is in the off position.
4. Reconnect the power cord, replace the chassis top cover and push the unit
back into the rack.
5. Finish by turning the power switch on the power supply on, and then depress
the power buttons on the front of the chassis.
Figure 6-4. Removing the Power Supply
6-6