Omron NX Series Hardware User Manual page 141

Name
End Plate
Not all of the combinations of the DIN Tracks and End Plates listed above are possible.
Confirm applicability of the combinations in the following table.
DIN Track model
PFP-50N
PFP-100N
NS 35/ 7,5 PERF
NS 35/ 15 PERF
Also, use screws and washers of the following sizes to fix the DIN Tracks.
(a): Dimensions from the screw head to the fastening surface
(a)
DIN Track model
PFP-50N
NS 35/ 7,5 PERF
NS 35/ 15 PERF
If you use any DIN Track other than those listed in the table above, refer to the dimensions shown in
5-3-12 Assembled Appearance and Dimensions on page 5-31 and use proper screws and washers.
l DIN Tracks
PFP-100N/50N DIN Track
4.5
15 25
10
NS 35/ 7,5 PERF
25
15
NX-series NX102 CPU Unit Hardware User's Manual (W593)
Model
PFP-M OMRON Corporation
CLIPFIX 35 Phoenix Contact
PFP-M
(OMRON)
Possible
Possible
Possible
Not possible
Applicable
screw size
M4 4.1 mm max.
M6 4.6 mm max.
M6 10 mm max.
25 25 25
10
1,000 (500) *1
R0.8
6.2
R0.8
27
35
1
7.5
Manufacturer
Two End Plates are required for each
CPU Rack.
Two End Plates are required for each
CPU Rack.
Possible
Possible
Possible
Possible
(a)
±
7.3 0.15
±
±
35 0.3
27 0.15
15 (5) *1
1
*1. PFP-50N dimensions are
given in parentheses.
5 Installation and Wiring
Remarks
CLIPFIX 35
(Phoenix Contact)
5-13
5