Table of Contents
Advertisement
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 7981," on page 53 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code
Description
001-250-000
Failed processor board ECC.
001-292-000
Core system: failed/CMOS checksum failed. Load the BIOS default settings by using the
001-xxx-000
Failed core tests.
001-xxx-001
Failed core tests.
005-xxx-000
Failed video test.
030-xxx-000
Failed internal SAS interface test.
035-xxx-099
No adapters were found.
075-xxx-000
Failed power supply test.
44
BladeCenter HS20 Type 7981: Problem Determination and Service Guide
Action
1. Reseat the following components:
a. DIMMs
b. (Trained service technician only)
Microprocessor 1
c. (Trained service technician only)
Microprocessor 2
2. Replace the following components one at a time,
in the order shown, restarting the blade server
each time:
a. DIMMs
b. (Trained service technician only)
Microprocessor
c. (Trained service technician only)
Microprocessor 2
d. (Trained service technician only) System
board assembly
Configuration/Setup Utility program and run the test
again (see the Installation and User's Guide for your
blade server).
(Trained service technician only) Replace the system
board assembly.
(Trained service technician only) Replace the system
board assembly.
(Trained service technician only) Replace the system
board assembly.
(Trained service technician only) Replace the system
board assembly.
Reseat the adapter (if installed).
Replace the power supply (see the Hardware
Maintenance Manual and Troubleshooting Guide or
Problem Determination and Service Guide for your
BladeCenter unit).
Advertisement
Table of Contents
