Maintenance And Care - Rinnai RH-C759-SB Operation & Installation Manual

Disconnect the power supply cord before carrying out
any cleaning or maintenance activities. It is important
to clean and/or replace the filters at appropriate
intervals as grease deposits build-up increases the risk
of fire. Do not operate the extractor hood without
grease filter.
Grease filter (Fig. 10)
•
Grease filters are used to absorb the grease
particles formed during cooking process. The filters
must be removed and cleaned every 4 weeks,
depending on frequency of usage. Clean the filter
either by hand or in the dishwasher. Note: Take
care not to bend the filters during washing.
• If by hand washing, soak the filters in warm
detergent solution to simplify the removal of
grease. Brush the filters, rinse thoroughly and
leave it to dry before refitting.
•
If by dishwasher, select an appropriate wash
program. Leave it to dry before refitting. Note:
slight discoloration of the filter may occur.
•
Removing and inserting the grease filters:
To remove, depress the handle and pull down
o
at the same time.
To refit, slot the filter into position. Make sure
o
that the handle is visible on the outside.
Charcoal filter (where applicable) (Fig. 11)
•
The charcoal filters should be replaced when it is
noticeably dirty or discolored, usually after 6 to 12
months depending on the conditions of use.
• These filters are not washable and cannot be
restored. To ensure that this appliance functions
effectively, regular maintenance is necessary as
clogged filters restrict airflow and may cause the
motor to overheat.
•
Removing and inserting the charcoal filter:
Remove the saturated charcoal filter from the
o
blower as shown.
Fit in the new charcoal filter.
o

MAINTENANCE AND CARE

Fig. 10
Cleaning the appliance body
•
Clean the extractor hood using warm detergent
solution and a soft damp cloth. Wipe dry with a lint-
free cloth.
•
Avoid using corrosive or abrasive products that could
damage the surface.
Light replacement (Fig. 12 & 12.1)
Replace the light bulb with another which has the
same characteristics as a higher voltage bulb could
damage the electrical unit.
•
Removing and replacing the lights:
Push out the light assembly from inside of the
o
hood body (Fig. 12).
Disconnect the light connector (Fig. 12.1).
o
Replace a new set of light assembly. Note: For
o
purchase of spare part, please check with your
local Rinnai Rinnai Customer Care Centre for
assistance.
Reverse the procedure for refitting.
o
You are strongly recommended to follow these safety
instructions. The manufacturer will not be held liable for
any damages to the appliance or any fire hazard due to
failure to observe the above safety recommendations.
6
Fig. 11
Fig. 12
Fig. 12.1