Operation - Rinnai RH-C759-SB Operation & Installation Manual

Aligning the hood body (if necessary) (Fig. 9)
• Before attaching hood body to wall, adjust the
2(two) screws located on the hood body mounting
points.
• Hook the hood body onto the support screws and
tighten the support screws fully.
•
Adjust screws to level the hood body.
To achieve better air extraction, we recommend you to switch on the blower a few minutes before starting to cook.
Leave it on for approximately 15 minutes after cooking or till all cooking smell is completely removed.
Switch control
Note: Touch the sensor buttons gently to operate this appliance.
On/delay/Off key: Touch to select on/off. When in operating mode, press once to enter into delay mode; default delay
timer is 1 minute. Gently slide through the ten-key slider to adjust the delay time: slide to the right to increase timing, slide
to the left to decrease timing. Maximum delay timing is 10 minutes. When in countdown mode, display will show the time,
and slider indicator will show the speed. Press the on/off key to exit delay timer mode, and to turn off the blower/fan.
Lights on/off: Touch to select lights on/off
Timer setting: When in "off" mode, press and hold the on/off key to enter clock settings. Once the display starts blinking,
press to decrease hour unit and
for the minutes display.
Low speed: Press to turn blower on/off at low speed
Medium speed: Press to turn blower on/off at medium speed
High speed: Press / to turn blower on/off at high speed
Touch slider: Gently slide across to the right to increase blower speed, and across to the left to lower blower speed
Installation must be performed by qualified personnel
only.
improper installation and does not accept responsibility
for appliance warranty in the event of damage caused by
incorrect installation.
Fig. 9

OPERATION

to increase hour unit. After that, press
5
The manufacturer declines all responsibility for
to confirm and proceed to do the same