Reinstall Components - Juniper SRX5600 Manual

Figure 7: Lift the Firewall into the Rack
4. Slide the chassis onto the mounting shelf until the mounting brackets contact the rack rails. The shelf
ensures that the holes in the mounting brackets and the front-mounting flanges of the chassis align
with the holes in the rack rails.
5. To install the chassis in an open-frame rack, install a mounting screw into each of the open mounting
holes aligned with the rack, starting from the bottom.
6. Visually inspect the alignment of the chassis. If the chassis is installed properly in the rack, all the
mounting screws on one side of the rack should be aligned with the mounting screws on the
opposite side and the chassis should be level.

Reinstall Components

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis. For more information about ESD, see the SRX5600 Firewall
Hardware Documentation at www.juniper.net/documentation/.
12