Advertisement
How to Set Up Your JSA7500 Appliance
Select one of the following Internet protocol:
12.
IPv6—Internet Protocol version 6.
IPv4—Internet Protocol version 4.
Select
. The Management Interface window appears.
Next
13.
Select port 0 to specify as the management interface and then select
14.
Enter the values for the following parameters to configure the JSA Settings:
15.
Hostname - Type a fully qualified domain name as the system hostname.
IP Address - IP address of the system.
Network Mask - Network mask for the system.
Gateway - Default gateway address.
Primary DNS - Primary DNS server address.
Secondary DNS—Optional. Secondary DNS server address.
Public IP—Optional. Public IP address of the server.
Email server— E-mail server name. If you do not have an e-mail server, specify the local host in this field.
Select
Next
. The New Root Password window appears.
16.
Enter your new password, and select
17.
Re-enter your new password to confirm, and select
18.
this process takes from three-to-five minutes. When the JSA installation process is complete, the message window appears.
Step 7: Finish Installation
Select
to complete the installation.
1.
OK
Type exit and press
Enter
2.
Step 8: Verifying the Settings
Verify the appliance configuration settings:
Open your Web browser.
1.
Log in to JSA with the username admin and the password <root password>.
2.
<root password> is the new root password that you set during the configuration process.
6
Next
. The Confirm New Root Password window appears.
Finish
.
.
Next
. A series of messages appears as JSA continues with the installation;
Copyright © 2018, Juniper Networks, Inc.
Advertisement
