Install The Firewall Without A Mechanical Lift - Juniper SRX5600 Manual

3. Using the lift, position the firewall in front of the rack or cabinet, centering it in front of the mounting
shelf.
4. Lift the chassis approximately 0.75 in. above the surface of the mounting shelf, and position it as
close as possible to the shelf.
5. Carefully slide the firewall onto the mounting shelf so that the bottom of the chassis and the
mounting shelf overlap by approximately 2 in.
6. Slide the firewall onto the mounting shelf until the mounting brackets contact the rack rails. The shelf
ensures that the holes in the mounting brackets and the front-mounting flanges of the chassis align
with the holes in the rack rails.
7. Move the lift away from the rack.
8. Install a mounting screw into each of the open mounting holes aligned with the rack, starting from
the bottom.
9. Visually inspect the alignment of the firewall. If the firewall is installed properly in the rack, all the
mounting screws on one side of the rack should be aligned with the mounting screws on the
opposite side and the firewall should be level.

Install the Firewall Without a Mechanical Lift

Lifting the chassis and mounting it in a rack requires at least two people. The empty chassis weighs
approximately 65.5 lb (29.7 kg).
1. Ensure that the rack is in its permanent location and is secured to the building.
2. Position the chassis in front of the rack or cabinet, centering it in front of the mounting shelf. Use a
pallet jack if one is available.
3. With one person on each side, hold onto the bottom of the chassis and carefully lift it onto the small
mounting shelf. See Figure 7 on page 12.
11