Table of Contents
Advertisement
15.9
Checking the headlight setting
Main work
–
Turn protection cap
socket counterclockwise all the way and remove it.
–
Pull bulb socket
V01783-10
–
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / socket PX43t) (
–
Insert the protection cap with the bulb socket into the reflector
and turn it clockwise all the way.
Info
Ensure that O-ring
E00359-10
–
Insert the bulb socket of the position light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
ELECTRICAL SYSTEM 15
1
together with the underlying bulb
2
of the position light out of the reflector.
3
.
p. 160)
4
is seated properly.
p. 127)
B
under the first marking.
5 cm (2 in)
A
5 m (16 ft)
p. 128)
p. 126)
away from the
127
Advertisement
Table of Contents
