Stihl MSA 220.0 T Instruction Manual page 43

26 Specifications
For technical information regarding the
STIHL AP and AR series batteries, see the prod‐
uct information accompanying your battery.
For technical information regarding the
STIHL AL 101, 301, 301-4 and 500 series charg‐
ers, see the product information accompanying
your charger.
Batteries, chargers and other accessories sold
separately. Contact your authorized STIHL serv‐
icing dealer for pricing and availability.
26.2 Chain Sprockets
The following chain sprockets are available for
this model chain saw:
– 6-tooth for 3/8" PICCO pitch
– Maximum chain speed: 23.3 m/s
26.3 Minimum Groove Depth of
Guide Bars
The minimum groove depth of a guide bar
depends on the pitch of the guide bar.
– Minimum groove depth for 3/8" PICCO pitch
guide bars: 0.197 in. (5 mm)
26.4 Depth Gauge Setting
The depth gauge setting of a saw chain depends
on the pitch of the chain.
– Depth gauge setting for 3/8" PICCO pitch
chains: 0.026 in. (0.65 mm)
26.5 Ambient Temperature Limits
WARNING
■ Extreme temperatures can damage the battery
and may also cause it to generate heat, rup‐
ture, leak, ignite or explode, resulting in severe
or fatal personal injury or property damage.
Never charge, use or store the battery outside
the ambient temperature limits specified
below.
► Do not charge the battery below - 4 °F (-
20 °C) or above 122 °F (50 °C).
► Do not use the chain saw or battery below
‑ 4 °F (- 20 °C) or above 122 °F (50 °C).
► Do not store the chain saw or battery below
- 4 °F (- 20 °C) or above 158 °F (70 °C).
26.6 Ambient Temperature Recom‐
mendations
For optimum performance, observe the following
ambient temperature ranges for the chain saw
and battery:
– Charging: 41 °F to 104 °F (5 °C to 40 °C)
0458-007-8201-B
– Use: 14 °F to 104 °F (- 10 °C to 40 °C)
– Storage: - 4 °F to 122 °F (- 20 °C to 50 °C)
Charging, using or storing the battery outside the
recommended ambient temperature ranges may
reduce performance.
If the battery became damp or wet during opera‐
tion, allow it to dry at least 48 hours at tempera‐
tures between 59 °F (15 °C) and 122 °F (50 °C)
and relative humidity below 70 % before charg‐
ing or storing. Higher humidity can extend the
drying time.
26.7 Symbols on the Chain Saw
Symbol Explanation
V Volt
IPX4 Protection against spraying or splash‐
ing water from all directions.
Maximum guide bar length
XXX
Saw chain
XXX
Maximum computed kickback angle
without chain brake / Maximum compu‐
ted kickback angle with chain brake
XXX / YYY
Power symbol on the retaining latch.
Engage and disengage the chain
brake.
Chain oil tank
Maximum guide bar length
Direction of saw chain rotation
Oil Flow Adjusting Screw
Turn clockwise to tension the saw
chain
STIHL products must not be disposed of in
the household trash, but only in accord‐
ance with local, state and federal laws and
regulations and as provided in this manual,
30.
26.8 Engineering Improvements
STIHL's philosophy is to continually improve all
of its products. As a result, engineering changes
and improvements are made from time to time.
Therefore, some changes, modifications and
improvements may not be covered in this man‐
ual. If the operating characteristics or the appear‐
ance of your machine differs from those descri‐
English
43