Table of Contents
Advertisement
Figure 38
1. Socket wrench
2. Idler-pulley nut
9.
While you are holding the idler pulley over
the access hole on the transmission, insert a
screwdriver through the access hole to catch a
rib on the idler pulley.
Figure 39
1. Screwdriver through
access hole
2. Access hole
10.
Use the screwdriver to hold the idler pulley out
of the way until you are done installing the new
transmission belt.
g281194
3. Access hole
4. Screwdriver
g280736
3. Idler pulley
4. Transmission belt
11.
From the front of the machine, remove the belt
from the motor pulley and then remove from the
transmission pulley.
Installing the Transmission Belt
1.
While the idler pulley is pulled out of the way,
install the new transmission belt placing the belt
over the transmission pulley first and then over
the motor pulley.
2.
Remove the screwdriver from the access hole in
the transmission to return the idler pulley to its
tensioned position.
3.
Use the rear-viewing window, located under the
rear-discharge deflector, to ensure that the new
transmission belt is positioned correctly.
4.
Install the trailing shield using the 2
trailing-shield bolts removed in Step
Removing the Transmission Belt (page
5.
Install the rear-viewing window, located
under the rear-discharge deflector, using the
corresponding bolt removed in
the Transmission Belt (page
Adjusting the
Parking-Brake Cable
Whenever you install a new parking-brake cable or
if the parking brake is out of adjustment, adjust the
parking-brake cable.
1.
Disengage the parking brake; refer to
Disengaging the Parking Brake (page
2.
Turn the adjustment nut counterclockwise to
loosen the cable adjustment
29
7
of
28).
6
of
Removing
28).
17).
(Figure
40).
Advertisement
Table of Contents
