Toro 25465 Installation Instructions

4ft and 5ft Manual Crumbers
RT1200 Trencher
Model No. 25465
Model No. 25465E
Model No. 25466
Model No. 25466E
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Crumber bar
Crumber blade (6 inches)
Crumber blade (8 inches)
Carriage bolt (1/2 x 4 inch)
Washer (1/2 inch)
Locknut (1/2 inch)
Spacer
Note: You should have either 2 people or lifting equipment
to perform this procedure.
1. Park the machine on a firm, level surface.
2. Move the boom to the horizontal position.
3. Turn off the engine and remove the key.
4. If the space between the mounting plates is too narrow
to insert the crumber bar between them, loosen the
4 bolts and the 4 locknuts that secure the crumber
mounting brackets to the boom enough so that you can
insert the crumber bar between them (Figure 1).
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Qty.
1
1
1
2 Install the crumber.
2
2
1
Register at www.Toro.com.
1
2
Figure 1
1. Crumber mounting bracket
(2)
2. Bolts
Original Instructions (EN) All Rights Reserved *3378-118* A
Printed in the USA
Form No. 3378-118 Rev A
Installation Instructions
Use
3
3. Locknuts
g025236