Operation; Lowering And Raising The Blade; Adjusting The Blade Angle - Toro 79216 Operator's Manual

Operation

Important This snow blade should be used for
plowing snow only.
Caution
If you hit fixed objects with the blade, the traction
unit could stop abruptly, causing you to lose
control, sustain personal injury, and equipment
damage.
Travel at a safe, slow speed.
Check the area to be plowed and mark all fixed
objects so that you can avoid them.
Lowering and Raising the
Blade
Use the lift lever to lower and raise the blade (Fig. 16).
To rest the blade on the ground, put the lift lever in the
lowest position.
Figure 16
1. Lift lever
Note: Raise the lift lever to highest position when
transporting the blade.

Adjusting the Blade Angle

There are five positions for the side to side angle of the
blade. To change the blade angle, perform the following
procedure:
1. Raise the blade.
2. Push the index lever forward with one hand (Fig. 17)
while positioning the blade with the other hand until
you have reached the desired blade angle.
3. Release the index lever.
Note: The angle pin must snap into the hole in the channel
to retain the blade position.
1
1. Index lever
m–6421
9
1
Figure 17
m–5566