After Operation; After Operation Safety; Haul The Machine - Toro Ultra Buggy 2500 Operator's Manual

Operating the Hopper (continued)
1. Position the machine in the area where you intend to dump the load.
2. Dump the hopper
• Pull the dump handle
• Press down on the forward part of the dump
pedal
3. Move the hopper to the upright position
either of the following:
• Push the dump handle
• Press down on the rear part of the dump
pedal

After Operation

After Operation Safety

General Safety
• Engage the parking brake, shut off the engine, remove the key (if applicable), and wait
for all movement to stop before adjusting, cleaning, or repairing the machine.
• Do not touch parts that may be hot from operation. Allow them to cool before attempting
to maintain, adjust, or service the machine.
• Clean debris from drives, mufflers, and the engine to help prevent fires. Clean up oil or
fuel spills.
• Use care when loading or unloading the machine into a trailer or truck.

Haul the Machine

Use a heavy-duty trailer or truck to haul the machine. Use a full-width ramp. Ensure that the
trailer or truck has all the necessary brakes, lighting, and marking as required by law. Please
carefully read all the safety instructions. Knowing this information could help you or
bystanders avoid injury. Refer to your local ordinances for trailer and tie-down requirements.
3461-467A
by either of the following:
down.
.
up.
.
by
g025722s
Page 4–9 Operation: After Operation