Lifting The Machine - Toro Ultra Buggy 2500 Operator's Manual

Moving a Non-Functional Machine (continued)
Do not tow or pull the machine without bypassing the parking brake or you will
damage the hydraulic system.
1. Place the hopper in the dump position and
remove the cowl.
2. Rotate the bypass valve counterclockwise to
tow the machine.
3. Tow the machine as required using the tie
down locations.
Do not push or tow the machine faster than 3 to 4.8 km/h (2 to 3 mph) for longer than 3
minutes, because you may damage the transmission. The bypass valves must be
open whenever you push or tow the machine.
4. Rotate the bypass valve clockwise to operate the machine normally.

Lifting the Machine

Lifting the Machine with a Hoist
Ensure that the hopper is empty before lifting the machine.
1. Place the platform in the raised position.
2. Place the hopper in the dump position.
3. Attach a chain or straps to each of the 3 lift
points located under the hopper.
4. Remove any slack in the chains or straps to
ensure that the machine is properly balanced.
Lifting the Machine with a Forklift
Ensure that the hopper is empty before lifting the machine.
1. Place the platform in the raised position.
Maintenance: Pre-Maintenance Procedures
IMPORTANT
G357878s
IMPORTANT
g358012s
Page 5–3 3461-467 A