Operator Platform - Toro Ultra Buggy 2500 Operator's Manual

Operating the Machine (continued)
3. Adjust the throttle lever to the desired engine
rpm
4. Disengage the parking brake lever
5. Move the machine in the desired direction:
A. forward—squeeze the speed-control-lever
on the right handle bar
B. rearward—squeeze the speed-control
lever on the left handle bar
Note:
faster the machine travels.
6. Release the speed control handle and press
the brake pedal to stop the machine
7. Engage the parking brake
engine.

Operator Platform

You can use the machine with the platform in the up or down position.
The operator platform is heavy and may cause injury when you raise or lower it.
Carefully lower or raise the operator platform, as suddenly dropping it could injure
you.
• Do not put your hands or fingers in the platform-pivot area when lowering or
raising the operator platform.
• Make sure that the platform is supported when you pull the latch pin out.
• Make sure that the latch secures the platform when folding it up. Push it tight
against the cushion for the latch pin to lock into place.
• Keep bystanders away from the machine when raising or lowering the platform.
Operate the machine with the platform up for the following conditions:
• Using the machine near drop-offs
• Using the machine in small areas where the machine is too large
• Areas with low-hanging branches or obstacles
• When loading or unloading the machine from a trailer for transport
• Driving up slopes
Operate the machine with the platform down for the following conditions:
• Using the machine in most areas
• Driving across slopes
3461-467A
.
The more you squeeze the handle, the
.
.
.
.
and shut off the
G357351s
WARNING
Page 4–7 Operation: During Operation