Epson WF-2110 Series User Manual page 66

Table of Contents

In These Situations

1. Hold down the [WPS] button on the wireless router until the security light flashes.

If you do not know where the [WPS] button is, or there are no buttons on the wireless router, see the

documentation provided with your wireless router for details.

2. Hold down the

button on the printer for at least 5 seconds until the

flash alternately.

The connection setting will start. When a connection is established, the

Note:

The printer is in a connection error status when the

clearing the printer error by pressing the

printer and try again. If it still does not work, print a network connection report and check the solution.

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can connect to an wireless router by using a PIN code that is printed on the network status sheet. You can use

this method to set up if an wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a

PIN code into the wireless router.

1. Load papers.

2. Hold down the

button on the printer for at least 5 seconds.

The network status sheet is printed.

Re-Setting the Network Connection

button on the printer, reboot the wireless router, place it close to the

Making Wi-Fi Settings from the Control Panel

light and the

light turns on.

light flash simultaneously. After

light

Table of Contents