Adding The Gear Oil - Husqvarna TC 65 2020 Owner's Manual

16.3

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
SERVICE WORK ON THE ENGINE 16
Info
Too little gear oil or poor-quality gear oil results in pre-
mature wear to the transmission.
–
Remove filler plug
Gear oil
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
M01559-10
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove screw
E00535-10
–
Remove filler plug
–
Add gear oil until it flows out of the hole of the gear oil level
plug.
Engine oil (15W/50) (
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
M01559-10
–
Mount and tighten filler plug
2
with the O-ring, and fill up with gear oil.
0.50 l Engine oil (15W/50)
(0.53 qt.) (
p. 100)
1
.
2
with the O-ring.
p. 116)
1
.
M6 6 Nm (4.4 lbf ft)
2
with the O-ring.
p. 116)
101