16 Service Work On The Engine; Checking The Gear Oil Level; Changing The Gear Oil - Husqvarna TC 65 2020 Owner's Manual

16 SERVICE WORK ON THE ENGINE

16.1
16.2
100

Checking the gear oil level

E00535-10

Changing the gear oil

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Drain gear oil with engine at operating temperature.
E00534-10
Condition
The engine is cold.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
1
Remove screw .
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
Add the gear oil.
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
Preparatory work
–
Stand the motorcycle on the plug-in stand on a horizontal
surface.
Main work
–
Place an appropriate container under the engine.
–
1
Remove oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten the oil drain plug with the magnet and new
seal ring.
Guideline
Oil drain plug with
magnet
( p. 101)
1
.
M6 6 Nm (4.4 lbf ft)
with the magnet.
M12x1.5 20 Nm (14.8 lbf ft)