Husqvarna TC 65 2020 Owner's Manual page 79

Warning
Danger of accidents Brake linings which have not
been approved alter the braking efficiency.
Not all brake linings are tested and approved for
Husqvarna motorcycles. The structure and friction
coefficient of the brake linings, and thus their brake
power, may vary greatly from that of original brake
linings.
E00559-10
If brake linings are used that differ from the original
equipment, compliance with the original homologa-
tion is not guaranteed. In this case, the vehicle no
longer corresponds to its condition at delivery and
the warranty shall be void.
–
Only use brake linings approved and
recommended by Husqvarna motorcycles.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned
in the holding spring.
–
Position the brake caliper.
–
Mount and tighten screw
Guideline
Screw, front brake
linings
–
Mount lock washer
–
Mount screws
Guideline
E00557-10
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the hand brake lever in the activated position.
The brake caliper straightens.
–
Tighten screws
Guideline
Screw, front
brake caliper
–
Remove the locking piece of the hand brake lever.
BRAKE SYSTEM 12
5
.
M6 10 Nm (7.4 lbf ft)
4
.
6
, but do not tighten yet.
M8 20 Nm (14.8 lbf ft)
6
.
M8 20 Nm (14.8 lbf ft)
®
Loctite 243™
®
Loctite 243™
77