Setting Up A/V Receiver Control; Power And Volume - Mitsubishi Electric Unisen 154 Series Owner's Manual

68
6. NetCommand Control of an A/V Receiver (265 Series)

Setting Up A/V Receiver Control

Power and Volume

Perform this setup to control A/V receiver power and
volume with the TV's remote control.
To perform this setup you need:
• The remote controls for both the TV and the
A/V receiver.
• An IR emitter cable available from Mitsubishi.
Before You Begin
1.
Connect your A/V receiver to the TV and any addi-
tional devices.
2.
Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See "IR Emitters," page 61.
3.
TV's remote control to TV mode.
Set the
Setup to Control A/V Receiver Power and Volume
1.
Inputs > AVR menu.
Open the
2.
The first function highlighted in the
always Power. Aim the TV's remote control at the
TV and press ENTER to begin learning for Power.
Inputs > AVR screen. Perform
NetCommand IR "learning" for A/V
receiver power and volume keys.
Downloaded From TV-Manual.com Manuals
For assistance call 1(800) 332-2119
3.
4.
5.
6.
AVR screen is
Get other manuals https://www.bkmanuals.com
When the Power text starts flashing, aim the A/V
receiver's remote control at the TV and hold the
POWER or POWER ON key until a check mark appears
next to Power.
• If the text stops flashing before the check mark
appears, repeat this step.
• To remove the key from NetCommand control,
press the CANCEL key while the key name is
highlighted.
Press the key on the TV's remote control to highlight
other keys in the list. Repeat steps 2 and 3 for each
additional function you wish to control through NetCom-
mand.
If the A/V receiver has a separate
press on the TV's remote to highlight Power
Off. Repeat steps 2 and 3 to "learn" the POWER OFF
key. If the device has no POWER OFF key, skip this
step.
When finished "learning" the power and volume
keys, press EXIT to watch TV or continue
NetCommand setup if using an HDMI connection.
See "Automatic Audio/Video Switching Over an
HDMI Connection" on the opposite page
POWER OFF key,