Mitsubishi Electric Unisen 154 Series Owner's Manual page 71

Setting Up A/V Receiver Control, continued
NetCommand Control of a Device Con-
nected to an HDMI A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
You must have already completed the procedure under
"Setup to Control Automatic Audio and Video Switch-
ing via HDMI" on the opposite page. That procedure
placed an icon in the Input Selection menu for the
device (input) connected to the A/V receiver.
Any Connection
Source
Device
Downloaded From TV-Manual.com Manuals
6. NetCommand Control of an A/V Receiver (265 Series)
HDMI
Type Cable
A/V
Receiver
Get other manuals https://www.bkmanuals.com
1.
Set up NetCommand control of A/V receiver audio/
video switching via HDMI as described on the
opposite page.
2.
Press
normal TV viewing.
3.
Press
4.
Highlight the icon for the A/V receiver input you
wish to control.
5.
Press
and the A/V receiver to the input.
6.
Open the
7.
Perform NetCommand "learning" for the con-
nected )device by following the steps in "Initial
NetCommand Setup," page 62.
TV
For assistance call 1(800) 332-2119
EXIT to close any open menus and return to
INPUT.
ENTER to switch the TV to the A/V receiver
Inputs > Learn menu.
71