Charging Led Indicators - Panasonic KX-HNC710W Installation Manual

charge in locations outside of
these temperatures.
Charge for about 7 hours.
R Turn the camera off before
charging the battery. If the
camera is turned on while
charging, it may take longer to
charge.
1
Open the USB cover (A).
2
Insert the USB cable into the
micro-USB connector (B).
2
1 Power off
2 5.0 V, 1.0 A or higher power
source
We recommend using the
supplied USB cable.
3 Charging LED indicator
Note:
R Check the charging LED
indicator continues to blink in
For assistance, please visit http://shop.panasonic.com/support
HNC710_(en_en)_0207_ver.110.pdf
3
2
1
1
15
red for more than 10 seconds
after connecting the USB cable.
If the indicator stops blinking
and turns off within 10 seconds,
perform the following.
– If you are not using the
supplied USB cable, use it.
– If the indicator still turns off
within 10 seconds, try
connecting the USB cable to
a different power source
(5.0 V, 1.0 A or higher).
Charging LED
indicators
You can use the charging LED
indicators to confirm the charging
status of the camera.
Indicator Status
Red, lit Charging is
completed
Red, blinking Charging
slowly
Red, blinking Charging
quickly failure
Setup
15
2018/02/07 20:11:47